I had a request from a friend for a zombie phone case and after a little bit of thinking this was the result. The thing that really makes it great, I think, is the hanging out eyeball and I can’t take any credit for that whatsoever – I saw it on an amigurumi bunny of doom at a blog called A Clockwork Angel and instantly knew it had to be the focal point of the phone case.
To make this case first follow the instructions for the flower phone case in grey (or green would look good) up to step 6. Go on, go do that now – we’ll wait for you….
Done that now? and your phone fits nicely inside? Good then let’s continue:
You don’t have to have a strap to close the top but I think the fact it’s on one side instead of central and that it hooks around the ‘good’ eye all adds to the creepy/quirkiness. Maybe there used to be a strap on the other side too but that eye just couldn’t take the strain….? If you want a strap too then stop your dc spiralling towards one side and chain long enough to loop down to the centre of the case while the phone is in it. Now dc into the next stitch of the case and slip stitch the next few stitches.
If you have fluffy yarn like I did then change to this yarn and complete a couple of rounds of 1dc in each stitch – keep going until there is as much hair as you want. If you don’t have fluffy yarn then fasten off the grey yarn and you could tie lengths of a contrasting colour yarn around individual stitches on the top of the case and trim them into tufts. This will be more time-consuming but you have more freedom for the hairstyle – odd random tufts, male pattern baldness or a Mohican maybe.
If you are using a strap then the button eye should be positioned first and used as a basis to build the rest of the face. Put the phone into the case to locate the best position for the button so that the strap fastens easily and securely. For the popping out eye I used a small black bead inside a larger white bead but as you can see on the Bunny of Doom just a black bead looks great too. Thread the bead onto a length of pink thread or thin yarn and repeatedly knot the thread to create the eye entrails (or whatever they’re actually called!) until it is a good dangling length. Using black thread sew a patch opposite the button to act as an eye socket and pull the ends of the pink thread through either side of the centre of the socket. Tie the ends together and trim inside the case.
Finally using black thread again sew a mouth as shown in the photos or in any expression you like, I’m sure the options are endless!